FixVault
Home › Chevrolet › 2005 › Avalanche 2500 › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls - 4.3L (Introduction)) › Repair Instructions › Ignition Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra and 2005 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the ignition control module (2) and heat sink (3).
  2. Install ignition control module (2) screws.

    Tighten:  Tighten the screws to 3.5 N.m (31 lb in).

  3. Connect the ignition coil driver electrical connector (3).
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
About FixVault