FixVault
Home › Chevrolet › 2005 › Blazer 4D Utility, 4WD, Part Time › Repair and Diagnosis › External Pages › Different car › Section 5 (Engine Controls - (Introduction) Specifications & Repair Instructions) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Safari and 2005 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Disconnect the electrical connector (3).
  3. Remove the screws (4) holding the ignition control module (2) and the heat sink (1) to the bracket.
  4. Remove the ignition control module and the heat sink.
About FixVault