FixVault
Home › Chevrolet › 2005 › Chevy Express G1500, Van Cargo, 4.3 X › Repair and Diagnosis › Engine Performance › System › Engine Control System - 4.3L - Introduction › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
    2. Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (3).
  3. Remove the screws (4) holding the ignition control module (2) and the heat sink (1) to the bracket.
  4. Remove the ignition control module and the heat sink.
About FixVault