FixVault
Home › Chevrolet › 2005 › Chevy Express G3500, Van Passenger Extended › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Control System - 4.3L - Introduction) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
    2. Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (3).
  3. Remove the screws (4) holding the ignition control module (2) and the heat sink (1) to the bracket.
  4. Remove the ignition control module and the heat sink.
About FixVault