FixVault
Home › Chevrolet › 2005 › Classic › Repair and Diagnosis (Single Page) › Engine Performance › System › Engine Control System (Introduction) - 2.2L (L61) › Repair Instructions › Knock Sensor (KS) Replacement › Removal Procedure

Removal Procedure

  1. Remove the starter. Refer to Starter Motor Replacement (2.2L (L61)) in Engine Electrical.
    2. Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) harness connector.
  3. Remove the KS retaining bolt.
  4. Remove the KS.
About FixVault