Conditions for Running the DTC

Rich Test Enable

• DTCs P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0128, P0201-P0204, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P1621 are not set.
• The ECT Sensor parameter is more than 70° C (158° F).
• The Ignition 1 Signal parameter is more than 11 volts.
• The Fuel Level Sensor parameter is more than 10 percent.
• The Engine Run Time parameter is more than 10 seconds.
• The Loop Status parameter is closed.
• The TP Sensor parameter is between 8-50 percent.
• The MAP Sensor parameter is more than 20 kPa.
• DTC P0132 runs continuously during the rich test when the above conditions are met for 4 seconds.

Decel Fuel Cutoff Test Enable

• DTCs P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0128, P0201-P0204, P0220, P0300-P0304, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P1621 are not set.
• The Loop Status parameter is closed.
• The decel fuel cutoff is active for more than 2.5 seconds.
• DTC P0132 runs continuously during decel fuel cutoff test when the above conditions are met for 4 seconds.