Conditions for Running the DTC

DTCs P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0128, P0201-P0204, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P1621 are not set.
The ECT Sensor parameter is more than 70° C (158° F).
The Ignition 1 Signal parameter is more than 11 volts.
The Fuel Level Sensor parameter is more than 10 percent.
The Engine Run Time parameter is more than 200 seconds.
The Engine Speed parameter is between 1,000-3,500 RPM.
The MAP Sensor parameter is between 10-104 kPa.
The Air Flow Calculated parameter is more than 15 g/s.
The Loop Status parameter is closed.
The TP Sensor parameter is between 5-60 percent.
The EVAP Purge Solenoid command is more than 35 percent.
DTC P0133 runs once per drive cycle when the above conditions are met for 0.75 second.