FixVault
Home › Chevrolet › 2005 › Classic › Repair and Diagnosis › External Pages › Different car › Section 3 (Antilock Brake System And Traction Control System) › Repair Instructions › Traction Control Switch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Traction Control Switch & Front Floor Console Trim Plate
    GM182735Courtesy of GENERAL MOTORS CORP.
  1. Install the traction control switch into front floor console trim plate by pressing into place until fully seated and retaining clips are fully engaged.
  2. Connect the traction control switch wiring harness connector to the traction control switch.
    3. Fig 2: View Of Front Floor Console Trim Plate & Screws
    GM182780Courtesy of GENERAL MOTORS CORP.
  3. Align the front floor console trim plate to the front floor console and carefully press the retaining clips into the correct mounting holes in the front floor console.
  4. Close the front floor console cupholder.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the two screws that retain the front floor console trim plate to the front floor console.

    Tighten:  Tighten the two retaining screws to 2 N.m (18 lb in).

  6. Close the front floor center console armrest.
  7. Verify the repair. Refer to Diagnostic System Check - ABS .
About FixVault