FixVault
Home › Chevrolet › 2005 › Classic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - Introduction & Repair Instructions › Repair Instructions › Low/Reverse Servo Assembly Replacement › Removal Procedure

Removal Procedure

    CAUTION: Refer to Vehicle Lifting Caution in Cautions and Notices.
  1. Raise the vehicle. Support the vehicle.
  2. Remove the oil pan and filter. Refer to Oil Filter and Seal Replacement .
  3. Remove the oil feed pipes. Refer to Oil Feed Pipes Replacement .
    4. Fig 1: View Of Low/Reverse Servo Assembly
    GM588858Courtesy of GENERAL MOTORS CORP.
  4. Remove the three low/reverse band servo cover bolts, the servo and the spring.
  5. Disassemble, clean and inspect the low/reverse servo assembly. Refer to Low and Reverse Servo Disassemble in Automatic Transmission Transaxle Unit Repair Manual.
About FixVault