FixVault
Home › Chevrolet › 2005 › Cobalt SS › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Controls - 2.2L - (Introduction)) › Repair Instructions › Accelerator Controls Pedal Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the connector position assurance (CPA) from the accelerator pedal position (APP) sensor connector.
  2. Disconnect the APP sensor harness connector.
  3. Remove the APP assembly attachment bolts from the brake pedal assembly.
    4. Fig 2: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  4. Remove the APP assembly from the vehicle.
About FixVault