FixVault
Home › Chevrolet › 2005 › Cobalt SS › Repair and Diagnosis › Transmission › Manual Trans › Manual Transaxle - Mu3 › Repair Instructions › Shift Control Assembly Replacement › Installation Procedure

Installation Procedure

    Fig 1: Locating Floor Pan Grommet & Mounting Nuts
    GM867994Courtesy of GENERAL MOTORS CORP.
  1. Position the shifter on the studs and install the front 2 nuts (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 rear nuts (3).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  3. Install the shift cables. Refer to Shift Control Cable Replacement .
  4. Install the console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
About FixVault