FixVault
Home › Chevrolet › 2005 › Cutaway 4.8 V › Repair and Diagnosis › Accessories & Equipment › Entertainment Systems › Cellular Communication System › Repair Instructions › Bracket Assembly Replacement - OnStar Module › Installation Procedure

Installation Procedure

    Fig 1: Pulling End Of Module Away From Bracket
    GM871219Courtesy of GENERAL MOTORS CORP.
  1. Slide the module (3) into the mounting bracket (1).
  2. Push the module (3) towards the mounting bracket (1) at the end near the tab (2).

    Push until the module (3) is seated in the mounting bracket (1).

    3. Fig 2: Coaxial Cable, Electrical Connectors & Module
    GM871220Courtesy of GENERAL MOTORS CORP.
  3. Install the module and bracket (2) to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts (3).

    Tighten:  Tighten the bolts (3) to 3 N.m (27 lb in).

  5. Connect the coaxial cable and the electrical connectors (2) to the module.
  6. Install the drivers knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.
About FixVault