FixVault
Home › Chevrolet › 2005 › Equinox LS, AWD › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.4L - Introduction › Repair Instructions › Knock Sensor (KS) Replacement › Removal Procedure

Removal Procedure

IMPORTANT: This engine is equipped with 2 knock sensors. This service procedure applies to both the right and left knock sensors
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Knock Sensors
    GM909629Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) electrical connector.
  3. Remove the KS bolt.
  4. Remove the KS.
About FixVault