FixVault
Home › Chevrolet › 2005 › Equinox LT, AWD › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.4L - Introduction › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Installation Procedure

Installation Procedure

  1. Lubricate the CMP sensor O-rings with clean engine oil.
    2. Fig 1: View Of CMP Sensor
    GM1087797Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the CMP sensor electrical connector.
About FixVault