FixVault
Home › Chevrolet › 2005 › Impala LS › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Computer/Integrating Systems › Repair Instructions › Body Control Module Replacement › Installation Procedure

Installation Procedure

  1. Install the BCM (1).
    Fig 1: Body Control Module & Electrical Connectors
    GM614333Courtesy of GENERAL MOTORS CORP.
  2. Connect the BCM electrical connectors (2, 3, 4).
  3. Install the left instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  4. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  5. Perform the new BCM setup. Refer to Control Module References .
About FixVault