FixVault
Home › Chevrolet › 2005 › Impala LS › Repair and Diagnosis › Engine Performance › System › Engine Control System - 3.8L (L36 And L67) - Introduction (2 Of 2) › Repair Instructions › Air Cleaner Assembly Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Air Cleaner Housing
    GM444479Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner housing by pushing the housing into the 2 rubber grommets (2) in the engine compartment.
  2. Install the PCM (4) and the harness into the air cleaner housing (1).
    3. Fig 2: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner housing cover assembly (1).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 screws (2) into the 2 air cleaner housing sections.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Install the left inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
About FixVault