Installation Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the ECM into the bracket on the battery tray.
- Push down on the ECM until the retaining tab snaps into place.
- Connect the engine wiring harness electrical connectors (1) to the ECM.
- Slide the lever locks to the down position in order to engage the engine wiring harness electrical connectors.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LE5, LE9, LY7) .
- If a NEW ECM was installed, program the ECM. Refer to Control Module References .