Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Position the spring on the lower control arm.
Use the jack stand to raise the lower control arm into position.

Fig 1: Identifying Lower Control Arm To Knuckle Bolt And Nut
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .
Install the lower control arm to knuckle bolt, nut, and inboard fastener.
Tighten: Tighten the bolt and nut to 60 N.m (44 lb ft) plus an additional 60 degrees.

Fig 2: Identifying Coil Spring

Courtesy of GENERAL MOTORS CORP.

Remove the OTC 204-167 or equivalent on vehicle spring compressor to compress the coil spring.
Remove the jack stand.
Install the rear tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.