FixVault
Home › Chevrolet › 2005 › Impala LS › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Forward Servo Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  1. Install the spring.
  2. Install the piston assembly.
  3. Install the O-ring.
  4. Install the servo cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  6. Remove the drain pan from under the forward servo cover.
  7. Adjust the jackstand in order to raise the rear of the frame.
  8. Install the frame bolts. Refer to Frame Replacement in Frame and Underbody.
  9. Remove the support from the rear of the frame.
  10. Install the power steering lines to the right side of the frame.
  11. Install the engine mount lower nuts. Refer to Engine Mount Replacement - Right in Engine Mechanical - 3.4L or Engine Mount Replacement - Right in Engine Mechanical - 3.8L.
  12. Install the transaxle mount lower nuts. Refer to Transmission Mount Replacement - Left .
  13. Install the power steering gear. Refer to Power Steering Gear Replacement in Power Steering System.
  14. Lower the vehicle.
  15. Remove the engine support fixture.
    16. NOTE: Refer to Do Not Overfill the Transmission Notice in Cautions and Notices.
  16. Check and fill the transaxle as necessary.
About FixVault