FixVault
Home › Chevrolet › 2005 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 1192 (Power Steering System) › Repair Instructions › Power Steering Pump Flow Control Valve Replacement - Off Vehicle › Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Flow Control Valve
    GM1776816Courtesy of GENERAL MOTORS COMPANY
  1. Install the power steering pump flow control valve spring (2) into the power steering pump housing (1).
  2. Install the power steering pump flow control valve (3) into the power steering pump housing (1).
  3. Lubricate the power steering pump flow control valve fitting O-ring seal (4) with power steering fluid.
  4. Install the power steering pump flow control valve fitting O-ring seal (4) onto the power steering pump flow control valve fitting (5).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the power steering pump flow control valve fitting (5) to the power steering pump housing (1).

    Tighten the fitting to 60 N.m (44 lb ft).

About FixVault