FixVault
Home › Chevrolet › 2005 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 1192 (Power Steering System) › Repair Instructions › Steering Gear Boot Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rack and pinion outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
    2. IMPORTANT:

    Mark the location of the steering gear inner tie rod nut before removing it from the steering gear inner tie rod.

  2. Remove the steering gear inner tie rod nut and discard it.
  3. Remove the outer steering gear boot clamp.
  4. Remove the inner steering gear boot clamp and discard it.
    5. Fig 1: View Of Steering Gear Boot
    GM854991Courtesy of GENERAL MOTORS COMPANY
  5. Disengage and remove the steering gear boot from the steering gear.
  6. Inspect the sealing surfaces and threaded shaft portion of the steering gear and the steering gear inner tie rod. The surfaces must be clean and free of any debris.
About FixVault