FixVault
Home › Chevrolet › 2005 › Impala SS › Repair and Diagnosis › External Pages › Different car › Section 892 (Wiper System & Washer System) › Repair Instructions › Windshield Wiper System Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor
    GM1471742Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor (1). Refer to Windshield Wiper Motor Replacement .
  2. Connect the electrical connector to the wiper motor.
  3. Connect the clip retaining the electrical harness to the wiper module.
    4. Fig 2: View Of Wiper Drive System Module
    GM1471736Courtesy of GENERAL MOTORS CORP.
  4. Position the wiper module assembly (2) into the plenum.
    5. NOTE: Refer to Fastener Notice .
  5. Install the fasteners (1) attaching the wiper module assembly to the plenum.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
  8. Inspect the washers for proper operation.
About FixVault