FixVault
Home › Chevrolet › 2005 › Malibu Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - 2.2L (L61) - Introduction › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Removing & Installing Manifold Absolute Pressure Sensor
    GM897270Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  3. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
  4. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
  5. Remove the MAP sensor and the MAP sensor port seal if it is still retained in the intake manifold
About FixVault