FixVault
Home › Chevrolet › 2005 › Malibu Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Floor Shift Control Replacement › Removal Procedure

Removal Procedure

  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    2. Fig 1: Removing & Installing Shifter Cable From Control Assembly
    GM944208Courtesy of GENERAL MOTORS CORP.
  2. Using a J 36346  , disconnect the shifter cable from the control assembly pin. See Special Tools .
  3. Remove the shifter cable from the control assembly.
    4. Fig 2: Park Lock Cable Assembly & Pin On Control Assembly
    GM944348Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the park lock cable assembly from the pin on the control assembly.
    5. Fig 3: Removing & Installing Indicator Bulb By Rotating Bulb A Quarter Turn And Pulling Out
    GM945404Courtesy of GENERAL MOTORS CORP.
  5. Remove the indicator bulb by rotating the bulb a quarter turn and pulling out.
    6. Fig 4: Control Assembly Electrical Connectors
    GM944353Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the control assembly electrical connectors.
    7. Fig 5: Removing & Installing Nuts From Control Assembly
    GM944361Courtesy of GENERAL MOTORS CORP.
  7. Remove the nuts from the control assembly.
  8. Remove the control assembly and replace if necessary.
About FixVault