FixVault
Home › Chevrolet › 2005 › Malibu LS › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Control System - 2.2L (L61) - Introduction) › Repair Instructions › Ignition Control Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Ignition Control Module
    GM896789Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Disconnect the electronic ignition (EI) module harness connector.
  3. Remove the EI module attachment screws and the EI module.
About FixVault