FixVault
Home › Chevrolet › 2005 › SSR Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System - 6.0L - Introduction › Repair Instructions › Spark Plug Wire Replacement › Removal Procedure

Removal Procedure

  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
    2. Fig 1: View Of Spark Plug Wire & Boot
    GM343699Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the spark plug wire at each spark plug.
    • Twist each spark plug wire 1/2 turn.
    • Pull only on the boot in order to remove the wire from each spark plug.
  3. Disconnect the spark plug wire from the ignition coil.
    • Twist each spark plug boot 1/2 turn.
    • Pull only on the boot in order to remove the wires from the ignition coil.
About FixVault