FixVault
Home › Chevrolet › 2005 › SSR Automatic › Repair and Diagnosis › External Pages › Different car › Section 142 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Sensing and Diagnostic Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Sensing & Diagnostic Module
    GM887089Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the SDM to the vehicle and install the nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  2. Connect the wire harness and install the CPA retainers.
  3. Install the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    4. IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
About FixVault