FixVault
Home › Chevrolet › 2005 › SSR Automatic › Repair and Diagnosis › External Pages › Different car › Section 212 (Engine Controls (Introduction)) › Repair Instructions › Accelerator Pedal with Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accelerator Pedal Mounting & Bolts
    GM43535Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
  2. Install the accelerator pedal mounting bolts.

    Tighten:  Tighten the accelerator pedal mounting bolts to 20 N.m (15 lb ft).

    3. Fig 2: Accelerator Pedal Sensor Module Electrical Connector
    GM43534Courtesy of GENERAL MOTORS CORP.
  3. Connect the accelerator pedal sensor module electrical connector.
  4. Inspect for correct carpet fit under the accelerator pedal.
  5. Install the left I/P on the lower closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages and Console.
About FixVault