FixVault
Home › Chevrolet › 2005 › SSR Standard › Repair and Diagnosis › Brakes › Antilock Brake System And Traction Control System › Repair Instructions › Brake Pressure Modulator Valve (BPMV) Replacement › Removal Procedure

Removal Procedure

    Fig 1: Electronic Brake Control Module (EBCM) View
    GM778051Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the electronic brake control module (EBCM) from the vehicle. Refer to Brake Pressure Modulator Valve (BPMV) Replacement .
    3. IMPORTANT: In the following service procedures, insert rubber plugs or caps on the exposed brake pipe fittings to prevent brake fluid loss and contamination.
  3. Remove the left front brake pipe.
    4. Fig 2: Removing/Installing Right Front Brake Pipe
    GM778058Courtesy of GENERAL MOTORS CORP.
  4. Remove the right front brake pipe.
    5. Fig 3: Removing/Installing Rear Brake Pipe
    GM778046Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear brake pipe.
    6. Fig 4: Removing/Installing Brake Pipe To Brake Master Cylinder
    GM778043Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pipe to the brake master cylinder.
About FixVault