FixVault
Home › Chevrolet › 2005 › SSR Standard › Repair and Diagnosis › External Pages › Different car › Section 143 (Engine Controls - Introduction) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Manifold Absolute Pressure Sensor
    GM894678Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
  3. Remove the MAP sensor attachment bolt and remove the MAP sensor with the grommet.
About FixVault