FixVault
Home › Chevrolet › 2005 › SSR Standard › Repair and Diagnosis › External Pages › Different car › Section 146 (Battery, Charging System And Starting System) › Repair Instructions › Battery Negative Cable Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When routing new cable, ensure enough cable is left near the battery to make connections at the end of this procedure.
  1. Route the new negative battery cable along the harness and secure using plastic tie straps.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the negative battery cable to the vehicle ground locations, left upper frame rail and transaxle case.

    Tighten:  Tighten the negative battery cable to chassis to 12.5 N.m (9.5 lb ft).

  3. Install the battery. Refer to Battery Replacement .
About FixVault