FixVault
Home › Chevrolet › 2005 › SSR Standard › Repair and Diagnosis › External Pages › Different car › Section 212 (Engine Controls (Introduction)) › Repair Instructions › Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Duct
    GM1465271Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the arrow on the MAF/IAT sensor is pointing to the front, radiator, indicate the proper air flow direction. The arrow must point toward the engine.
  1. Install the MAF/IAT sensor (5) in the air cleaner housing (6).
  2. Install the air intake duct (4).
  3. Position the clamps (3) on the air intake duct (4).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the clamps (3).

    Tighten:  Tighten air intake duct and MAF/IAT sensor (2) to 4 N.m (35 lb in).

  5. Reconnect the MAF/IAT electrical connector (1).
  6. Reconnect the electrical connector (1).
About FixVault