FixVault
Home › Chevrolet › 2005 › SSR Standard › Repair and Diagnosis › External Pages › Different car › Section 221 (Seat System) › Repair Instructions › Seat Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seat & Components
    GM1247931Courtesy of GENERAL MOTORS CORP.
  1. Position the seat on the rear studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seatbelt and the retaining nut to the seat stud.

    Tighten:  Tighten the nut to 41 N.m (31 lb ft).

  3. Connect the electrical connectors, if equipped with a power seat.
  4. Install the nuts to the rear studs.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  5. Move the seat rearward.
  6. Install the nuts to the front adjuster legs.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  7. Install the adjuster leg covers.
  8. Secure the covers with push pins.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in SIR.
About FixVault