Solvent Container, Pump, Level Sensor Replacement - Windshield Washer

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Washer Solvent Container, Pump & Level Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the left front wheel. Refer to Tire and Wheel Removal and Installation . Remove the left fender liner. Refer to Fender, Insulator, Liner, Brake Caliper Cooling Duct Replacement - Front .
Headlamp Washer Solvent Container Replacement
1	Retainer, Headlamp Washer Solvent Tank (Qty: 1)
2	Bolt, Windshield Washer Solvent Container (Qty: 2) Tighten: 9 N.m (80 lb in)
3	Container Assembly, Windshield Washer Solvent Tip: Disconnect the washer hose and the drain washer solvent. Disconnect the electrical connector.
4	Cap, Washer Bottle
Windshield Washer Pump Replacement
5	Pump Assembly, Windshield Washer
6	Grommet, Windshield Washer Pump
Windshield Washer Solvent Level Switch Replacement
7	Seal, Windshield Washer Solvent Level Switch
8	Switch, Windshield Washer Solvent Level Tip: Drain the washer fluid and refill when finished with the replacement. Disconnect the electrical connector and reconnect when finished with the replacement. Using 2 flat-bladed tools, pry outward the washer solvent container level sensor switch from the solvent container. Use equal inward pressure to seat the level sensor switch into the seal.