Installation Procedure

If removed, install the drive axle seal.

Fig 1: View Of Case Extension Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the case extension housing (6) with the axle seal and with the O-ring (8).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the case extension housing bolts (5).
Tighten: Tighten the bolts (5) to 36 N.m (27 lb ft).
Install the vehicle speed sensor. Refer to Input Speed Sensor Replacement .
Install the transaxle brace. Refer to Automatic Transmission Brace Replacement (Front Wheel Drive) or Automatic Transmission Brace Replacement (All Wheel Drive) or Automatic Transmission Brace Replacement (Front Wheel Drive and All Wheel Drive) .
Connect the right drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
Lower the vehicle.

NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.

Adjust the fluid level. Refer to the following information.
- Transmission Fluid Checking Procedure .
- Fluid and Lubricant Recommendations in Maintenance and Lubrication
- Capacities - Approximate Fluid in Maintenance and Lubrication
Inspect for completion of the repairs.
Inspect for fluid leaks.