FixVault
Home › Chevrolet › 2005 › Venture Base, Van Cargo Extended › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System - Suspension Leveling › Repair Instructions › Automatic Level Control Sensor Replacement › Installation Procedure

Installation Procedure

  1. Install the automatic level control height sensor link onto the sensor arm.
  2. Install the automatic level control height sensor to the vehicle.
    3. Fig 1: Identifying Automatic Level Control Height Sensor Bracket Bolts
    GM881333Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the height sensor bracket bolts (1).

    Tighten:  Tighten the height sensor bracket bolts to 85 N.m (63 lb ft)

  4. Install the automatic level control height link to the tie rod ball stud. Refer to Automatic Level Control Sensor Link Replacement .
    5. Fig 2: View Of Automatic Level Control Sensor Electrical Connector
    GM881329Courtesy of GENERAL MOTORS CORP.
  5. Install the automatic level control height sensor electrical connector (1).
  6. Lower the vehicle.
  7. Perform the Diagnostic System Check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
About FixVault