FixVault
Home › Chevrolet › 2005 › Venture Base, Van Cargo Extended › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System - Suspension Leveling › Repair Instructions › Automatic Level Control Sensor Replacement › Removal Procedure

Removal Procedure

    IMPORTANT: When replacing the height sensor a diagnostic system check must be performed.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Automatic Level Control Sensor Electrical Connector
    GM881329Courtesy of GENERAL MOTORS CORP.
  2. Remove the automatic level control height sensor electrical connector (1).
  3. Remove the automatic level control height sensor link from the ball stud. Refer to Automatic Level Control Sensor Link Replacement .
    4. Fig 2: Identifying Automatic Level Control Height Sensor Bracket Bolts
    GM881333Courtesy of GENERAL MOTORS CORP.
  4. Remove the automatic level control height sensor bracket bolts (1).
  5. Remove the automatic level control height sensor from the vehicle.
  6. Remove the automatic level control height sensor link from the sensor arm.
About FixVault