FixVault
Home › Chevrolet › 2005 › Venture LS › Repair and Diagnosis › External Pages › Different car › Section 432 (Electronic Suspension System - Automatic Level Control) › Repair Instructions › Automatic Level Control Air Compressor Head Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the wires through the tie strap and the conduit.
    2. Fig 1: Automatic Level Control Air Compressor Head
    G01828556Courtesy of GENERAL MOTORS CORP.
  2. Install the O-ring (3) to the automatic level control air compressor.
  3. Install the air compressor head.
    NOTE: Refer to FASTENER NOTICE .
    4. Fig 2: Air Compressor Head Bolts Tightening Sequence
    G01828557Courtesy of GENERAL MOTORS CORP.
  4. Install the air compressor head bolts.

    Tighten 

    Tighten the air compressor head bolts in the order shown to 6 N.m (53 lb in).

  5. Install the wiring to terminals B and C on the automatic level control air compressor electrical connector.
  6. Install the air dryer to the automatic level control air compressor. Refer to Automatic Level Control Air Dryer Replacement .
  7. Install the automatic level control air compressor to the vehicle. Refer to Air Compressor Replacement .
About FixVault