FixVault
Home › Chevrolet › 2005 › Venture LS › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Front End Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Sensor Assembly
    GM742124Courtesy of GENERAL MOTORS CORP.
  1. Install the front end sensor to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 integral bolts that retain the front end sensor to the frame front crossmember.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  3. Connect the sensor electrical connector (2) to the front end sensor.
  4. Install the CPA to the sensor electrical connector.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
About FixVault