FixVault
Home › Chevrolet › 2005 › Venture LS › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Automatic Transmission Range Selector Cable Lever Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Automatic Transmission Range Selector Cable Lever
    GM161083Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transaxle range selector lever.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the automatic transaxle range selector lever nut.

    Tighten:  Tighten the automatic transaxle range selector lever nut to 32 N.m (23 lb ft).

  3. Install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever.
  4. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.4L.
About FixVault