FixVault
Home › Chevrolet › 2005 › Venture LS › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - Introduction & Repair Instructions › Repair Instructions › Automatic Transmission Range Selector Cable Replacement › Removal Procedure

Removal Procedure

  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Element Replacement in Engine Controls - 3.4L.
    2. Fig 1: Locating Automatic Transaxle Range Selector Cable Retaining Clip
    GM161164Courtesy of GENERAL MOTORS CORP.
  2. Use a flat-bladed tool in order to remove the retaining clip from the automatic transaxle range selector cable.
    3. Fig 2: View Of Automatic Transaxle Range Selector Cable
    GM368792Courtesy of GENERAL MOTORS CORP.
  3. Use a large flat-bladed tool in order to remove the automatic transaxle range selector cable from the cable lever.
  4. Use pliers in order to depress the cable retainers.
  5. Remove the automatic transaxle range selector cable from the automatic transaxle range selector cable bracket.
  6. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
    7. Fig 3: View Of Automatic Transaxle Range Selector Cable Retaining Clip
    GM161141Courtesy of GENERAL MOTORS CORP.
  7. Remove the retaining clip from the automatic transaxle range selector cable.
  8. Remove the automatic transaxle range selector cable from the column control lever.
    9. Fig 4: Removing/Installing Range Selector Cable From Steering Column Bracket
    GM161140Courtesy of GENERAL MOTORS CORP.
  9. Remove the automatic transaxle range selector cable from the steering column bracket.
    10. Fig 5: View Of Automatic Transaxle Range Selector Cable In The Cowl
    GM161138Courtesy of GENERAL MOTORS CORP.
  10. Remove the automatic transaxle range selector cable through the hole in the cowl.
About FixVault