Installation Procedure

Fig 1: View Of Forward Servo Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the forward band servo cover bolts.
Tighten: Tighten the bolts to 12 N.m (106 lb in).
Remove the drain pan from under the forward servo cover.

IMPORTANT: Ensure that the power steering cooler line does not become trapped or damaged during this step.

Use the utility stand in order to raise the frame rear.
Install the NEW frame bolts.
Adjust the utility straps as necessary in order to align the powertrain mounts with the frame.
Install the transaxle mount nuts. Refer to Automatic Transmission Mount Replacement .
Install the engine mount nuts. Refer to Engine Mount Replacement in Engine Mechanical - 3.4L.
Install the power steering gear to the frame. Refer to Power Steering Gear Replacement in Power Steering System.
Install the power steering gear heat shield.
Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement in Front Suspension.
Lower the vehicle.
Remove the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical - 3.4L.
Adjust the fluid level. Refer to the following information:
- Transmission Fluid Checking Procedure
- Fluid and Lubricant Recommendations in Maintenance and Lubrication.
- Capacities - Approximate Fluid in Maintenance and Lubrication.