FixVault
Home › Chevrolet › 2006 › Avalanche 2500 › Repair and Diagnosis › Engine Performance › System › Engine Control System - 8.1L - DTC P0506 To DTC U0107 › DTC P2108 › Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 4:  Locating and repairing an individual condition may correct more than 1 DTC.
DTC P2108

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 Replace the throttle actuator control (TAC) module. Refer to Throttle Actuator Control (TAC) Module Replacement .
Did you complete the replacement?		 Go to Step 3  -
3
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 4 
4  Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information System OK
About FixVault