FixVault
Home › Chevrolet › 2006 › Corvette Base, 2D Convertible, Standard › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pulley Replacement › Installation Procedure

Installation Procedure

Fig 1: View Of Power Steering Pump Pulley Installer
GM643361Courtesy of GENERAL MOTORS CORP.
  1. Using J 25033-C  , install the power steering pump pulley onto the power steering pump.
    IMPORTANT: The pulley must be installed onto pump shaft so that the pulley hub is flush with the pump shaft.
  2. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical-6.0L.
  3. Install the brake pressure modulator valve (BPMV) bracket. Refer to Brake Pressure Modulator Valve (BPMV) Bracket Replacement in Antilock Brake System.
  4. Install the brake pressure modulator valve (BPMV). Refer to Brake Pressure Modulator Valve (BPMV) Replacement in Antilock Brake System.
About FixVault