FixVault
Home › Chevrolet › 2006 › Corvette Base, 2D Convertible, Standard › Repair and Diagnosis › Steering › Steering Wheel & Steering Column › Repair Instructions › Steering Column Lock Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying The Lock Module In The I/P Carrier
    GM1400454Courtesy of GENERAL MOTORS CORP.
  1. Install the control module to the retaining bracket on the steering column.
  2. Connect the electrical connector to the lock module.
    3. Fig 2: Identifying Steering Column Electronic Lock Harness
    GM1400455Courtesy of GENERAL MOTORS CORP.
  3. Install the I/P Assembly. Refer to Instrument Panel (I/P) Assembly Replacement in Instrument Panel, Gages, and Console.
  4. Enable the SIR system. Refer to the following procedures:
  5. Program the lock control module. Refer to Control Module References in Computer/Integrating Systems.
About FixVault