FixVault
Home › Chevrolet › 2006 › Epica LTZ › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System › Repair Instructions › Wheel Speed Sensor Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: View Of Hub And Wheel Speed Sensor
    GM1255821Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The wheel speed sensor is served as an assembly, hub-wheel speed sensor. Therefore, the additional working procedure for air gap is not needed.
  1. Install the front hub unit. Refer to Steering Knuckle Replacement .
  2. Connect the front wheel speed sensor electrical connector.
  3. Lower the vehicle.
  4. Connect the negative battery cable.
About FixVault