FixVault
Home › Chevrolet › 2006 › HHR LS, Automatic › Repair and Diagnosis › Electrical › Starter › Battery, Charging System And Starting System › Repair Instructions › Battery Negative Cable Replacement › Installation Procedure

Installation Procedure

    Fig 1: Negative Battery Cable Bolt
    GM1631517Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the negative battery cable bolt (3) at the support.

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

    3. Fig 2: Body Harness Electrical Connector
    GM1631519Courtesy of GENERAL MOTORS CORP.
  3. Connect the body harness electrical connector (1) to the battery current sensor (3).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
About FixVault