FixVault
Home › Chevrolet › 2006 › HHR LS, Automatic › Repair and Diagnosis › Engine Mechanical › Engine Exhaust System › Repair Instructions › Catalytic Converter Replacement › Installation Procedure

Installation Procedure

NOTE: Do not bend the exhaust flex decoupler more than 3 degrees in any direction. Movement of more than 3 degrees will damage the exhaust flex decoupler.
  1. Install a NEW gasket to the exhaust manifold studs.
    2. Fig 1: Catalytic Converter
    GM1625682Courtesy of GENERAL MOTORS CORP.
  2. Install the catalytic converter to the exhaust manifold.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the catalytic converter nuts.

    Tighten:  Tighten the nuts to 46 N.m (34 lb ft).

  4. Install the post catalyst HO2S. Refer to Heated Oxygen Sensor Replacement - Position 2 or Heated Oxygen Sensor Replacement - Position 2 .
  5. Install the muffler. Refer to Muffler Replacement .
About FixVault