FixVault
Home › Chevrolet › 2006 › HHR LS, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls - 2.2L - Introduction (2 Of 2) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: MAP Sensor
    GM1581050Courtesy of GENERAL MOTORS CORP.
  1. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  3. Remove the MAP sensor.
    4. IMPORTANT: If the MAP sensor seal is damaged, the MAP sensor must be replaced.
  4. Inspect the seal for damage.
About FixVault