FixVault
Home › Chevrolet › 2006 › HHR LS, Automatic › Repair and Diagnosis › External Pages › Different car › Section 19 (Battery, Charging System And Starting System) › Repair Instructions › Battery Current Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Current Sensor
    GM1533512Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the battery current sensor electrical connector (2).
  2. Remove the battery negative cable from the vehicle. Refer to Battery Negative Cable Replacement .
  3. Remove the tape (3) securing the battery current sensor (1) to the negative battery cable (4).
    4. Fig 2: Battery Current Sensor
    GM1533515Courtesy of GENERAL MOTORS CORP.
  4. Remove the battery current sensor (2) from the ground end of the negative battery cable (1).
About FixVault